NEC GT2150 - Manual (Page 54)

E – 44
Color Matrix
First, select an appropriate color matrix for your input signal, either
HDTV or SDTV. Then select an appropriate matrix type from B-Y/
R-Y, Cb/Cr, Pb/Pr or IVX.
NOTE: The Color Matrix feature is available for component video signal
only.
Y/C Delay (not available for RGB)
Adjusts Y/C delay level.
Telecine
Use 3:2 pull down correction to eliminate jitter and artifacts in video.
Auto ............. For film source such as a DVD player
Off ................ For signals other than film sources
Motion Select:
Sets the interpolation method. Selects Still or Adaptive. Still is used
for non moving images such as a document camera. Select Adapter
for all motion video.
Motion Level
Adjusts level of motion detection when Adaptive is selected.
YTR Adjustmen (not available for RGB)
Adjusts luminance transient time.
CTR Adjustment (not available for RGB)
Adjusts chroma transient time.
Video Filter
This feature reduces video noise. Select the appropriate filter for
your signal.
Bar 0 ............ Off
Bar 1/3 ......... High
Bar 2/3 ......... Medium
Bar full ......... Low
Blanking
This feature allows you to mask any unwanted area of the screen
image.
Blanking On/Off:
This setting enables or disables the blanking function.
On ................ Blanking function is enabled.
Off ................ Blanking function is disabled.
* Adjustment of vertical display range
Adjust the Top, Bottom, Left or Right blanking with the SELECT ᮤ
or ᮣ button.
Video Adj
Noise Reduction
Select one of the following three levels for reducing video noise.
Low, Medium or High.
NOTE: The lower the Noise Reduction level, the better the image quality.
Increasing Noise Reduction lowers video bandwidth.