NEC 5330 IP - Manual (Page 83)

5330/5340 IP Phones – User Guide
83
Handset/Headset Combinations
The following combinations of corded and cordless headset and handset are supported on the
5330/5340 IP Phone:
•
Corded handset only
•
Corded headset only
•
Corded handset and corded headset
•
Cordless handset only
•
Cordless headset only
•
Cordless handset and cordless headset
•
Corded handset and cordless headset
•
Corded headset and cordless handset
Pairing the Cordless Module and Accessories
The cordless headset and handset are optional accessories, ordered separately. Before use, each
must establish communication with the Cordless Module using a procedure called pairing.
Notes:
•
An IP telephone can have only one cordless handset and one cordless headset
•
A cordless handset or headset can be paired with only one IP telephone at a time
•
Pairing a new cordless handset or headset with the IP telephone overwrites the
configuration of any previous handset or headset
•
Pairing cannot be performed when the cordless device is already in use.
Pairing a Cordless Accessory with the Cordless Module
To pair a cordless accessory:
1. Ensure that the battery of the cordless device to be paired is at least partially charged.
2. Press and hold down the pairing button on the back of the Cordless Module (see Figure 2
on page 82) for 5 seconds to activate telephone pairing mode. The LED on the Cordless
Module blinks. The Cordless Devices application opens on the telephone and prompts
you to “Press the pairing button on the cordless device now.
3. Press and hold down the hookswitch on the cordless handset or headset for 5 seconds to
activate accessory pairing mode. The LED on the cordless accessory blinks. After a
moment, the Cordless Devices application displays protocol, firmware, hardware, and
IPEI information for the device to be paired.
4. Press Yes to confirm pairing. The Cordless Devices application confirms the pairing by
displaying the paired device name and its battery level indicator.
5. Press Close to exit.