NEC 5330 IP - Manual (Page 84)

5330/5340 IP Phones – User Guide
84
To unpair a cordless accessory:
9. Press the blue Applications key and then press Cordless Devs.
10. Press the device name that you want to unpair. The information screen for the selected
device appears.
11. Press Unpair this Device. If the accessory is in use, an error message is displays.
Otherwise, the accessory is unpaired, removed from the display, and can no longer be
used to interact with the phone.
12. Press Close.
For more information about the Cordless Devices Application, see page 92.
Cordless Module LED Indicators
The Cordless Module has a blue light-emitting diode (LED) that indicates the current status of
the module (See Figure 1):
Blue LED Function
Solid Audio is active between the module and either the handset or headset.
Blinking Pairing mode is active or a firmware upgrade is in progress.
Off No audio is active.
Solid for 2 seconds Pairing is successful.
Blinking: LED is On and Off for equal amount of time
Using a Cordless Device as a Remote Control
When not being used to talk, the cordless handset/headset buttons can act as a remote control
device to change display contrast, volume, and mute settings on the host IP phone. For example,
in a remote handsfree conference setting, the chairman can use the volume and mute buttons on a
cordless device to adjust speaker levels and mute the microphone on an IP phone that is not
within his reach. HTML applications may also make use of the cordless device buttons but
functionality may differ among applications.