NEC Digital Telephone Xen IPK - Manual (Page 7)

5
Speed Dial – Using The Softkeys
Press the SYS. or STA. Softkey ( )
(System or Station Speed Dial respectively)
Press the UP or DOWN softkey ( ), repeatedly until the desired
name/number is displayed.
To search alphabetically (optional step):
Press the dial key showing the first letter of the name to be dialled
Continue to press this dial key until the desired letter is displayed
Press * to display the first match corresponding the chosen letter
Lift handset to dial the displayed name/number
Trunk Queuing
After dialling trunk access code or pressing a busy Line Key and receiving a line
busy indication:
Dial Trunk Queue set code 78
Replace handset
Note: When a line is available, your telephone will ring: lift handset and place call.
Microphone Control
Press MIC
or
Press Feature
Dial MIC On/Off code 1
Note 1: Lit MIC LED indicates MIC on
Note 2: MIC ON/OFF key may be assigned to a Feature Access Key or One Touch Key
Note 3: If talking on handset rather than handsfree, the handset microphone will be
muted and the MIC LED will flash.
Handsfree Calls
Press Speaker, LED lights
Ensure MIC LED is lit
Place internal or outside call
Converse
Press Speaker to disconnect call
Note: The handset may be used at any time during the conversation. To resume
handsfree operation or to monitor a call, press Speaker (LED lights) and
replace handset.
NEC Xen Phone UserGuide 18/7/2003 3:56 PM Page 5