Installation, Rear view of unimux-usbv-16hdu, Figure 4- install user touch screen monitor – Network Technologies UNIMUXUSBVXHD User Manual
Page 11
NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH
6
INSTALLATION
It is not necessary to turn OFF power to CPUs or monitors during this installation unless RS232 is going to be connected. All
cables, except for the RS232 cables, may be hot plugged.
If using RS232 Control see RS232 section
on page 31
for more information. Observe normal precautions when connecting the
RS232 cables to the CPU. Refer to the owner’s manual for the CPU being connected for precautions, if any.
1. Connect the 15HD male cable end from the user monitor to the female black 15HD port marked “MONITOR x” on the rear of
the UNIMUX switch (see Figure 3 ). If a touch screen monitor is being connected (models with touch screen support only),
connect the USB cable from the monitor to any one of the USB type A connectors in the same user device port group (see Figure
4 ).
Figure 3- Install user monitor
Figure 4- Install user touch screen monitor
VGA
Multi-Scan
Monitor
Existing Cable
250V,2A
12 4
11 3
10 2
9 1
CPU
CPU
16 8
15 7
14 6
13 5
CPU
CPU
NETWORK TECHNOLOGIES INCORPORATED 1275 Danner Drive, Aurora Ohio 44202 330-562-7070 www.networktechinc.com
MONITOR
RS232
Rear View of UNIMUX-USBV-16HDU
15HD Male
Video Connector
15HD Female
Video Connector
VGA
Touch Screen
Monitor
Existing Cable
250V,2A
12 4
11 3
10 2
9 1
CPU
CPU
16 8
15 7
14 6
13 5
CPU
CPU
NETWORK TECHNOLOGIES INCORPORATED 1275 Danner Drive, Aurora Ohio 44202 330-562-7070 www.networktechinc.com
MONITOR
RS232
Rear View of UNIMUX-USBV-16HDU
USB Type A Male
15HD Male
Video Connector
15HD Female
Video Connector
Existing Cable