Network Technologies UNIMUXUSBVXHD - Manual (Page 31)

NTI UNIMUX SINGLE-USER HIGH DENSITY VGA USB KVM SWITCH
26
Alternate Command Hot Key
To enable the administrator to assign a key in addition to the <`> (accent/tilde key) to use with <Ctrl> to enter into OSD
Command Mode, an Alternate Command Hot Key option is provided. The default factory setting for this option is <`> (disabling
the option).
To select an Alternate Command Hot Key, press <A> from the System configuration menu (page 21). A window will open and the
administrator will be prompted to press a key. Any key except Ctrl, Shift, Alt, Tab, Esc, or Enter can be used. After pressing the
key, a confirmation message will appear. The administrator should press <Y> (Yes) to validate the key as the Alternate Command
Hot Key, or <N> (No) to select another key.
Pressing <Esc> will return to the Administration Mode menu.
Only the administrator is able to set or change the Alternate Command Hot Key. This function must be set individually for each of
the USB User Device ports on the UNIMUX USB KVM switch.
Note: The Alternated Command Hot Key does not replace the <`> (accent) key, it just works as another way to enter into
Command Mode. After setting it, the user can enter into Command Mode either with <Ctrl> + <`> or with <Ctrl> +
<Alternate Command Hot Key> combination. To disable it, the administrator should set <`> as the Alternate Command
Hot Key.
Figure 32- Alternate Command Hot Key selection window
Reset Port names
To erase all configured port names and return them to the factory-default names, press <R> from the System Configuration menu.
After pressing the key, a confirmation message will appear. The administrator should press <Y> (Yes) to validate the selection or
<N> (No) to cancel it.
Pressing <Esc> will return to the Administration Mode menu.
The switch must be power cycled for the reset to take effect.
Select Keyboard Language
To enter the Select Language menu (see Figure 33) press
K from the System
Configuration menu described on page 22.
Only the administrator has the Select Language menu option.
The Select Language menu enables the administrator to select a specific
keyboard language (country code) to be used. Typically only SUN CPUs require
a specific country code to be registered at boot up. (For other types of CPUs this
feature may have no effect.) A list of available languages is displayed and can be
scrolled using the mouse (scroll wheel) and/or <up arrow>, <down arrow>,
<Home> and <End> keys.
Figure 33- Select Language menu