Neuro Logic Systems 17" User Manual
Page 4
RFT2 Rack Kit Installation Guide
07/01/06 Rev 1.0
Page 4 of 13
Step Detail
3. Remove the slides from the tray assembly. The
slides come shipped attached to the tray assembly,
the outer slide members must be removed to be
properly installed into the rack. To remove the outer
slide members, fully extend both slides to the open
position. Once extended unlock the outer slide
members by pressing or pulling on the blue tab on
the side of the slides. The outer slide member can
now be removed from the tray assembly. The inner
slides are left attached to the tray assembly.
Also remove the Cable Management System if
installed. This makes the installation easier.
4. Adjust the rear slide mounting brackets to the proper
depth. The rear slide mounting brackets are pre-
assembled, but may need to be adjusted to the
proper distance measured in step 2. The rear
bracket that will mount to the rack rails is free
sliding, so no screws are required.
5. Insert nut clips into the rack mounting rails as
required. If your rack has square or round untapped
holes, you will need to use 10-32 nut clips. Do not
place a nut in the center hole, this is just for
illustration purposes.