Neuro Logic Systems 17" - Manual (Page 8)

RFT2 Rack Kit Installation Guide
07/01/06 Rev 1.0 Page 8 of 13
Operating the LCD/Keyboard
NOTE: It is important to ensure that the monitor is connected and powered on prior to powering up the connected
server and/or KVM. Powering up the KVM then the server last will with some servers allow the video card and
monitor to self configure to the correct settings.
After the unit has been installed and all cables connected, power on the LCD monitor by lifting the head unit.
(There is a power button at the rear of the LCD which is actuated by lifting the head of the LCD monitor.) The LED
situated on the top of the LCD panel will alert you to its status. It will illuminate green when everything is working
properly. If the LED is orange, the monitor is powered up but not receiving a valid video signal.
Once the LCD monitor is powered on, power on the connected server and/or KVM and log in (or otherwise ensure
that a full screen image is displayed).
NOTE: If the monitor does not power up automatically when raised, the power button at the rear of the unit may
need to be cycled. There is also a Power button on the top of the LCD which may also need to be cycled.
NOTE: It is important to ensure that a full screen image is being displayed at the time the monitor is in the Auto-
Adjust function. The display may be mis-positioned if an image with a black border (such as a login screen) or
partial screen is used.