Neuro Logic Systems 17" - Manual (Page 7)

RFT2 Rack Kit Installation Guide
07/01/06 Rev 1.0 Page 7 of 13
Connecting your LCD/Keyboard
Step Detail
! Note: Before connecting the LCD monitor/keyboard to a KVM or
Server, all systems should be turned off.
1. The keyboard and trackball’s design allows it to be used with most Sun
systems. The RFT2 comes with a USB style connector.
2. The monitor uses a standard HD-15 or DVI male video connector. If
your Sun system uses a DB13W3 connection, you can use a Sun
adapter to interface between the LCD connector and the Sun system.
(PN: X3872A)
3. If both HD-15 and DVI cables are connected at the same time, HD-15
will be the default input.
4. Connect the monitor to a power source. The LCD Monitor’s power
supply is auto ranging, and will operate on AC voltages ranging from
90-264V and 50-60 Hz. The monitor uses an IEC 320-C14 connector
and a 2m IEC C13 to C14 cable is included. An adapter will be required
to interface with other connector types.
5. Secure the cables to ensure they will not bind when operating the
LCD/keyboard slide mechanism. Cycle the tray in and out of the
cabinet to ensure there is enough of a service loop in the cables. Zip
ties may be used to hold the cables securely to the back of the unit.
DVI HD-15
Power USB