NEC MultiSync XG-1352 - Manual (Page 15)

15
EXAMPLES OF CONNECTIONS
When used in stand alone operation.
Pin No.
14
5
10
4,8, and 12
SHORT/OPEN
SHORT
OPEN
SHORT
OPEN
SHORT
OPEN
12 8 4
OPEN OPEN OPEN
OPEN OPEN SHORT
OPEN SHORT OPEN
OPEN SHORT SHORT
SHORT OPEN OPEN
SHORT OPEN SHORT
SHORT SHORT OPEN
SHORT SHORT SHORT
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
The term “SHORT” means to connect with pin 15
• When in the external control mode, the POWER, INPUT and PICTURE MUTE buttons on the remote control will not function.
NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as the supplied
remote control from the external controller regardless of setting Pin 14.
NOTE: When turning the power on using the external control, short Pin 5 about three seconds after supplying the AC power to the
projector; when turning the power off using the external control, power off the AC supply to the projector about three seconds after
opening Pin 5. These procedures are to protect your projector and the connected equipment.
INPUT A
INPUT A
INPUT A
INPUT A
INPUT B
INPUT B
INPUT C
INPUT C
*1 Some settings allow you to retrieve a COMPONENT signal automatically. See “RGB/COMPONENT Search Setting” of the
Set-up manual.
*2 When the optional RGB input board is installed and the RGB input is set, an RGB signal will be selected; when the RGB input
board is installed and the COMPONENT input is set, a COMPONENT signal will be selected; when the optional RGB input board
is installed and the VIDEO input is set, a VIDEO signal will be selected.
When the optional VIDEO input board is installed, a VIDEO signal will be selected.
*3 An S-VIDEO signal will be selected when :
1. the optional RGB input board is installed and the VIDEO input is set.
2. the optional VIDEO input board is installed.
FUNCTION Remote button
RGB *1
VIDEO
S-VIDEO
COMPONENT
*2
*3
*2
*3
1
2
3
10
4
5
7
8
_
POWER ON
POWER ON
PICTURE
MUTE