NEC MultiSync XG-1352 - Manual (Page 34)

34
Data Area for Output and Storage
Adjustment data have different reference data areas depending on each operation.
Adjustment Area
All Gain : All adjustment data except Ref.Adjust data
Ref. Adjust : Ref.Adjust data
Adjustment data fall into two: REF. ADJUST menu adjustment and the other adjustment data (Operate and Adjust menu).
Data area falls into five:
Data Area
INPUT LIST (00-99) : Registered data (100) areas corresponding to INPUT LIST
DEFAULT DATA (1-6) : Default (6) areas divided by horizontal frequency.
Cancel Data : Data to be returned to default
Ref.Adjust Data : REF.ADJUST data (1) area
Ref.Adjust (FACTORY AREA) : REF.ADJUST data (1) area for factory preset.
NOTE: See the Set-up manual for ADJUST and REF.ADJUST menus.
Output Data Area
All Gain
Ref. Adjust Data
Ref. Adjust Data (Factory Area)
Ref. Adjust Data
←
Ref.Adjust Data
Input List (00-99) or Default Data (1-6)
Default Data (1-6)*
Input List (00-99)*
Cancel Data*
Signal Select
Normalize
Load
Cancel
* The above list may be different if NORMAL/LOAD/CANCEL operation is performed during POINT convergence.
Output data during adjusting is the amount of data in each data area and data other than the current adjustment item ( data in
working area).
Example for FINE adjustment
Point Data while adjusting Fine
Default Data (1-6) + Point data except the current Fine data
Input List (00-99) + Point data except the current Fine data
Cancel Data + Point data except the current Fine data
Normalize
Load
Cancel
Storage Area of Data
All Gain
INPUT LIST (00-99)*
Ref. Adjust
REF. ADJUST STORE
* Point adjustment has more than one item and each item has its own working area. However, there is only one area where data is
saved with the Store function, which means no distinction is made among items in data.