NEC MultiSync LT 80 - Manual (Page 15)

POSITION
MAGNIFY
REDUCE
PIC-MUTE FREEZE
VIDEO
RGB
MENU
R-CLICK
LASER
S-VIDEO VOLUME
+
−
+
+
−
−
OFF ON POWER
27
A Menu Button
Use this button to call up the On-Screen Menu so you can adjust and set
the image. After you press this button, it will light up. During this time
you can use the mouse pointer and right/left click buttons to make
menu selections. If no buttons are pressed within 10 seconds the menu
turns off.
B Mouse Pointer Buttons
Works as a mouse for your computer. This button is also used to adjust
screen position. Push (+) or (–) to select the submenu you want to
adjust.
C Right Click Button
Press this button to exit "Menus" or "Position."
D Freeze Button
This button will freeze a picture. Press again to resume motion.
E Position Button
When image is magnified, press this button to activate the mouse. This
allows you to select the portion of the image displayed on screen.
Position button will remain lit for 10 seconds or until right click button
is pushed.
F
E
C
D
A
B
INTRODUCTION 28
G
NOTE: When you are adjusting Position, the Mouse Pointer button is used to move
the picture.
F Picture Mute Button
This button turns off the image for a short period of time. Press again to
restore the image.
G Magnify/Reduce Button
Use the (+) or (–) button to adjust the image size up to 400%.
NOTE: You cannot use Menu and Position at the same time.
Remote Control Precautions
• Do not look into the laser pointer while it is on.
• Do not point the laser beam at a person.
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, remove the
batteries.
• Do not mix new and old or different types of batteries.