NEC MultiSync LT 80 - Manual (Page 32)

Settings Menu
Enables you to set preferences and other operating options. Use the “Select” button on the projector
cabinet or (▲) (▼) buttons on your remote control to access the submenu you want.
Custom Memory
This enables you to save your current settings for an RGB source in one of five memories, Custom
1-5.
To change the STANDARD settings, proceed as follows:
1. Connect your computer to the MultSync LT80.
2. Select the "STANDARD" in RGB source.
3. Adjust the horizontal/vertical position, Picture, and Fine Picture adjustments.
4. Select the Custom Memory icon.
5. Press the "Adjust" (+) or (–) buttons to choose a memory location, then press "Enter" on the cabinet
or the "Left Click" on your remote control to save the new settings.
If you do not want to change the STANDARD settings, first selct the Custom Memory icon, then do
the same as step 5.
61
Projection
This reorients your image for your type of projection. Press the “Adjust” (+) or (–) button until it is
correct. Press “Enter” on the cabinet or the “Left Click” on your remote control to save your change.
The options are: front floor projection, rear ceiling projection, rear floor projection, and front ceiling
projection.
Language
Use the “Adjust” (+) or (–) to choose one of six languages for on-screen instructions. Press “Enter”
on the cabinet or the “Left Click” on your remote control to save your change. The options are:
English, German, French, Italian, Spanish and Swedish.
Reset
Changes all adjustments to the factory preset levels for each source individually. To activate, you
must hold down the “Adjust” (+) button on the cabinet or remote control for at least two seconds.
The adjustments that will be reset are horizontal and vertical control, picture and fine picture adjust-
ment (for the current source only), brightness, contrast, color, tint, and sharpness.
When custom setting is selected, reset changes all adjustments to the factory preset levels of the
current input signal for selected custom memory location. This will not return to your previous
custom setting and will delete your saved settings from custom memory.
OPERATION 62