NEC MultiSync LT 80 - Manual (Page 28)

Enables you to select a video source such as a VCR, DVD player, laser disk player, compu-
ter or document camera depending on what is connected to your inputs. Press the "Select"
button on the projector cabinet or (▲) (▼) buttons on your remote control to highlight the
menu for the item you want to adjust
Video
Selects device connected to your video input (VCR, document camera, laser disk player or
DVD player).
S-Video
Selects device connected to S-Video input (Laser disk player, S-VHS VCR or DVD player).
Menu Descriptions & Functions
Source Menu
53
RGB
Selects computer connected to your RGB input. Use the "Adjust" (+) or (–) buttons to
select a standard* or one of six** custom settings you can create and store. Press the "En-
ter" button on the cabinet or the "Left Click" button on the remote control to save your
selection.
NOTE: If a previously saved custom memory location is used with a new or different input signal
it may not sync up, producing a distorted image, or no image at all. If so, follow the instructions
below:
1) Disconnect the signal cable so that there is no input signal. In this condition the on-screen
message will be displayed.
2) Select RGB standard from the source menu.
3) Connect the signal cable again.
NOTE:
* Standard is normally used and it can be user changed and automatically recalled.
** ”Custom 6” is read only. This feature is useful when an SVGA image (800
ן600) is displayed
with a notebook computer supported by XGA (1024
ן768).
OPERATION 54