NEC NEAX2000 ND-91649 User Manual
Page 12
CHAPTER 1
ND-91649(E)
Page 4
INTRODUCTION
Migration Path
For customers who are using the NEAX 7400 ICS M100MX*, the migration path is supplied. By replacing the
existing MP card to the new IPS MP card, the NEAX 7400 ICS M100MX* can be upgraded to IP/TSW Hybrid
System including new and enhanced service features introduced with the NEAX 2000 IPS.
For customers who are using NEAX 7400 ICS M100*/M80VS, by replacing existing PN-CP00/CP03 with
Retrofit MP and PN-CP01 with Retrofit FP, the NEAX 7400 ICS M100/M80VS can be upgraded to the NEAX
2000 IPS features. In case of NEAX 7400 ICS M100/M80VS Dual MP System the CP02 is replaced with
CP28-A Retrofit Dual MP. (See the following figure showing replacement of control cards. As for the LT/AP
card conditions after upgrading, refer to the “NEAX 2000 IPS Card Application List”.)
Figure 1-4 Retrofit MP/FP for Upgrading NEAX 7400 ICS M100 to IPS (Single MP System)
Figure 1-5 Retrofit MP/FP for Upgrading NEAX 7400 ICS M100 to IPS (Dual MP System)
* “NEAX 7400 ICS M100MX” is marketed in North/Latin America and Australia as “NEAX 2000 IVS
2
” and in UK as “NEAX 2000 INTEGRATED
VOICE SERVER.”
* “NEAX 7400 ICS M100” is marketed in North America as “NEAX 2000 IVS” and in Australia as “NEAX ICS 120”.
* “NEAX 7400 ICS M80VS” is marketed in Australia as “NEAX ICS 110”.
NEAX 7400 ICS M100 before upgrading
Replace MP/FP
MP: PN-CP00 to PN-CP26-A
FP: PN-CP01 to PN-CP17
Remove FP0 (CP01) mounted
in PIM0
NEAX 7400 ICS M100 after upgrading
NEAX 7400 ICS M100 before upgrading
Replace MP/FP
MP: PN-CP02 to PN-CP28-A
FP: PN-CP01 to PN-CP17
Remove FP0 (CP01) mounted
in PIM0
NEAX 7400 ICS M100 after upgrading
17-TW-0.3 CONN CA-A