NEC RIH-6867 - Manual (Page 9)

SMART
SLEEP
SUPER
Each time button is pressed, the operation mode
is changed in sequence:
MODE
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
18 ~32
Heating mode is NOT available for cooling only air conditioner.
HEATING COOLING DRY FAN ONLY
Selecting mode
FAN mode
2 + -
Auto High Medium Low
At "FAN ONLY" mode, only "High","Medium" and "Low" are available.
At "DRY" mode, airflow is set at "Low" automatically, "FAN" button
is ineffective in this case.
Setting temperature
Press once to temperature setting by 1 lower ℃
Press once to temperature setting by 1 raise ℃
Range of available set temperature
*HEATING, COOLING
DRY
FAN unable to set
room temperature
Turning on
SWING, SMART, TIMER, SLEEP and SUPER operation modes will be specified in the following pages.
Press button, when the appliance receives the
signal, the RUN indicator of the indoor unit lights up.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
During heating operation, air flow is not discharged at the beginning. After 2 5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
－
1
3
4
2
ONLY
Operation instructions
7
Operation modes
*Note: Heating mode is NOT available for cooling only models.
PDF created with pdfFactory Pro trial version www.pdffactory.com