Network Technologies 900GV - Manual (Page 28)

How to Install the Module
2-8 Installing the DIGITAL VNswitch 900GV
Task 4: Connect the LDM Port Cable
To perform a remote dump, the LDM cable must be connected to the LDM port. The
LDM port uses straight-through, 10BaseT, 8-pin MJ connectors.
To connect the LDM port cable to the LDM port (Figure 2-5), complete the following
steps:
Figure 2-5: LDM Port Cable Connection
Step Action
1 Align the release tab on the cable plug (1), with the keyway on the
module’s 10BaseT port connector.
2 Insert the plug into the connector, ensuring that the release tab snaps into
the locked position.
NPB-1051-98F
VNswitch 900GV FD DI/E th ern et
1
2