NetComm NP6800 - Manual (Page 12)

www.netcomm.com.au Rev.1 - YML655
Page 12 NP6800 - Wireless LAN Access Point
Installing the Access Point Utility
The Access Point Utility is used to configure and monitor the NetComm NP6800 - Wireless
LAN Access Point for all Windows operating systems.
The procedure described in this section can be used in order to install the Access Point Utility
under Microsoft® Windows®.
■ In this section it is assumed that you have a basic working knowledge of Microsoft
Windows and networking principles.
■ During the installation, you may be prompted to load operating system files from the
Windows installation disk. Please keep this disk handy.
■ You will need the CD provided with your Access Point.
To install the Access Point Utility:
1. Insert the provided CD into your CD-ROM drive and select Start -> Run and type in the
location of the software or browse for D:\AP Utility\Setup.exe, where D:\ is the letter of
your CD ROM drive.
2. The InstallShield Wizard will install Access Point Utility on your computer. To continue,
click Next.
3. Select the Program Folder for the Utility. The default folder will be 802.11 Wireless LAN.
Click Next to continue.
4. When the InstallShield Wizard has completed installation, click on the Finish button. Refer
to the section on Configuring the Access Point to set up your device.