NetComm NP6800 - Manual (Page 19)

Rev.1 - YML655 www.netcomm.com.au
NP6800 - Wireless LAN Access Point Page 19
Connecting to the Access Point using the SNMP Manager
1. Open Start->Programs->802.11 Wireless LAN->Acess Point Utility and click on
SNMP Manager. There are two ways to connect to the NetComm NP6800 - Wireless
LAN Access Point with the AP Utility:
■ Select File -> Connect to Access Point option and enter the IP and the Community.
■ Select File -> Find Access Point option. After a while a window will display any Access
Point devices that the Utilty has found.
Note: If the Access Point is found and displayed but you can not connect to it, you will
need to temporarily change your computer’s IP address. Refer to the section on
Assigning a temporary IP Address for further information.
2. From that window you can select the Access Point that you want to configure and click the
connect button. The Connect to Access Point window will appear with the correct IP
address displayed. Enter the Community in order to get access to the functionality of the
NetComm NP6800 - Wireless LAN Access Point.