NetComm NP6800 - Manual (Page 28)

www.netcomm.com.au Rev.1 - YML655
Page 28 NP6800 - Wireless LAN Access Point
Point to Point
This mode connects two physically separated LAN segments using two Wireless Access Points.
To configure a Point to Point bridged environment:
1. Click Point to Point.
2. Set the Remote MAC Address of the Access Point in LAN 1 to look for the MAC Address
of the Access Point in LAN 2.
3. The remote Access Point also needs to be set up as a Wireless Bridge.. In the Operational
Mode of the remote Access Point, set the Remote MAC address of the Access Point in
LAN 2 to look for the MAC Address of the Access Point in LAN 1.
Note: All devices on each LAN must be connected through a hub or switch.
4. Click the OK button to store the information.