NAD L 53 - Manual (Page 25)

25
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
COPY A COMMAND FROM ANOTHER BUTTON
You may copy a command from any HTR L53 button to any other. To copy a button function, after
entering the Learning Mode, and pressing the desired button to be copied to, simply press the device
button from which you wish to copy, having first pressed its Device Selector button if it resides on another
“page.” The status LED will turn green; press the Device Selector button again to exit Learning Mode.
Example: Copy the Pause command from the DVD page to the AMP button:
• On the HTR L53, simultaneously press-and-hold “AMP” and (OPEN/CLOSE); the Learn LED
turns steady green.
• Press (pause); the Learn LED turns amber.
• Press “CD”; press (pause); the Learn LED turns green.
• Press “AMP” again to exit the learning mode.
NOTE
• The copy and punch-through functions are similar. However, if you copy a command and then
subsequently delete, or over-write the original (source-button) command , the copied-to button’s
command remains unchanged. If you punch-through to a command and then delete or over-write the
original button, the punched-through functions also change accordingly.
MACRO COMMANDS
A “macro” command is a series of two or more remote codes issued automatically from a single
buttonpress. You might use a macro to automate a simple command sequence, such as, “Turn on the
DVD player and then press ‘play.’” Or you might compose an elaborate macro to power up an entire
system, select a source, choose a SURROUND MODE, and begin playback-again, all from a single
buttonpress. The HTR L53 can store one macro on each of its function buttons (these exclude the Device
Selector buttons).
NOTE
• Macros are independent of the currently selected device.
RECORDING MACROS
To record a macro, simultaneously press-and-hold for 3 seconds both the “MACRO” button and the HTR
L53 function button to which you wish to assign the macro, until the status LED turns green. The macro
button will also light up. Press the sequence of function buttons to be recorded into the macro, being
sure to first press the requisite Device Selector button for each function (you may switch devices while
recording the macro as many times as necessary), allowing you to create macro containing commands
from more than one Device Selector “page.” When you have finished entering the desired command
sequence, press “MACRO” again to store the macro; the Learn LED and “MACRO” button illumination
will turn off.
NOTE
• Each macro can store a maximum of 64 command steps. If you exceed this number, the macro will
be stored automatically after the 64th command is added.
Example: Record a Macro to the “0” button to Turn on the L53, Select the DVD Input, and
Commence Playback:
• On the HTR L53, simultaneously press-and-hold “MACRO” and “0” (numeric zero); the Learn LED
turns steady green.
• Press “AMP”; press “ON”; press “1” (orange “DVD”); press “DVD”; press “play” (the Learn LED
blinks as each step is added).
• Press “MACRO” again to exit the macro-record mode.
To clear a macro, perform the above steps without entering any functions.
USING THE HTR L53 REMOTE CONTROL
Operation
L53 IM english v3.qxd 7/20/2005 3:06 PM Page 25