NAD L 53 - Manual (Page 27)

27
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
DELETE MODE
The HTR L53 can store learned, copied, and “default library” commands on any single button. (The
default library commands are the pre-programmed NAD codes, such as the native L53 commands on the
“AMP” “page.”) You can delete commands by layers back “down” to the default library command on
any button, removing learned commands, punched-through functions, and copied buttons.
NOTE
•
The default library commands cannot be deleted, so you need not worry that using Delete Mode
might cause irreparable changes.
To enter Delete Mode, simultaneously press-and-hold for 3 seconds both the desired button’s Device
Selector button and the “RTN” button, until the Learn LED turns green. Press the function button whose
command you wish to delete; the Learn LED flashes; the number of times indicates which type of function
has become active-see the table below. Press the active Device Selector button again to exit Delete Mode.
NOTE
•
You may delete multiple function-button commands on the same Device Selector “page,” but to
delete from more than one Device Selector page you must exit Delete Mode and then re-enter it on
the required page.
Flashes Command Type
1 Default Library Command
2 Copied Library Command
3 Learned Command
LOADING CODE-LIBRARIES
The HTR L53 can store a different library of default NAD codes for each of its Device Selector “pages.” If
the original default library does not control your NAD CD player, tape deck, DVD player, or other
component, follow the procedure below to change the code-library.
Begin by ensuring that the component you wish the HTR L53 to control is plugged in and powered-up
(“on,” not merely in standby). To enter the HTR L53’s Library Mode, simultaneously press-and-hold for 3
seconds both the desired Device Selector button and the “PROGRAM” button, until the Learn LED turns
green. While keeping the HTR L53 pointed toward the component, enter the first appropriate three-digit
code-library number from the table below. If the component turns off, press “ENTER” to accept that
code-library number and exit the Library Mode. If the component does not turn off, enter the next three-
digit code-library number from the table. When you enter the correct number the component will turn
off; press “ENTER” to accept that code-library number and exit the Library Mode.
NAD-brand component HTR L53 code-library numbers
CD Player (new) 200
CD Player (old) 201
DVD T562 600
DVD T550, L55 601
DVD T531, T571 602
DVD T512, T532, T572 602
L56 604
DVD T513, T533 605
USING THE HTR L53 REMOTE CONTROL
Operation
L53 IM english v3.qxd 7/20/2005 3:06 PM Page 27