Nortel Networks CALLPILOT 555-7101-226 - Manual (Page 14)

703t server description Standard 1.01
14 CallPilot
The table below describes the parts that are identified in the preceding
diagram:
Part Function
Reset button Triggers a hardware (cold) reset. Do not use
this button to perform a server restart. Restart
the server as described in “Restarting the
server” in CallPilot Installation and
Configuration Part 1: Installation and
Maintenance Overview (555-7101-210).
Network
controller LEDs
(green) Left: 10/100Base-T controller LED
(NIC1 10/100 MB: ELAN
for Meridian 1/Succession 1000 connection)
Right: 10/100/1000Base-T controller LED
(NIC2 1 GB: CLAN
for Customer LAN connection)
Sleep mode button Not used
Power button Turns the server’s power on or off.
Status LEDs Indicate when the server is powered up and the
disk drives are active.
„ Left: hard drive activity LED (not used)
„ Center: power/sleep LED (green)
„
Right: status LED (bi-color) indicates
whether the server is functioning properly,
or whether a hardware event has occurred.
USB connector For future use
Floppy disk eject
button Ejects the floppy disk.
Floppy drive Drive for 3-1/2 inch diskettes.