NISSAN 2011 Maxima - Manual (Page 25)

Black plate (26,1)
08NJ-N Edited: 2010/ 10/ 18
2-18 Getting started
SEARCHING FOR DESTINATION
As an example, the method for setting a
restaurant as the destination using [Places] is
described here.
1. Push <DEST>.
2. Highlight [Places] and push <ENTER>.
3. Highlight [Nearby RESTAURANT] and push
<ENTER>.
INFO:
The search can also be narrowed down by
selecting [All Categories or Name] or
[ZAGAT] on this screen. By selecting [All
Categories or Name], the area, name of
facility, etc. can be specified. By selecting
[ZAGAT], restaurants registered in the ZA-
GAT database can be searched and sorted
by its rating regarding food, decor, cost,
service, etc.
4. Highlight the preferred restaurant from the
list and push <ENTER>.
INFO:
. The position of the selected location is
displayed in the preview on the right side
of the screen.
. If there is a route already in progress, only
places along the current route will be
listed. Turn off [Show Along Route] at the
top of list to display all nearby places.
5. The entire route is shown on the map.
Highlight [Start] after confirming the location
of the displayed destination, and push
<ENTER>.
The system sets the destination to the
selected location and starts calculating a
route.
INFO:
Even after setting a destination, the location
of the destination can be adjusted, the route
can be stored, etc. if necessary.
“Procedures after setting destination”
(page 5-2)
SETTING DESTINATION