NEC 2300 DL - Manual (Page 34)

Output Tray 26
Check your application to determine how to set your margins for duplex
printing.
1
To print duplex (both sides of the sheet), load the media printing-side up.
a For Tray 1, load the media with the top of the media toward the back of
the tray.
b For Tray 2, load the media with the top of the media toward the right
side of the tray.
"#
In autoduplexing, the back side is printed first and the front side is
printed last.
2
Set the driver for the duplex layout you prefer.
Long Edge creates a document that flips horizontally as in a loose-leaf
notebook; Short Edge creates a document that flips vertically, as on a
clipboard.
3
Click OK .
Output Tray
All media is output to the output tray on top of the printer. The face-down
output tray has a capacity of 200 sheets of 22 lb (80 g/m
2 ) bond paper.
"#
If the media is stacked too high, your printer may experience media
jams, excessive media curl, or static buildup.
"#
Remove transparencies as soon as possible from the output tray to
avoid static buildup.
Media Storage
How do I store media?
! Keep media on a flat, level surface in its original wrapper until it is time to
load it.
Media that has been stored for a long time without staying in its packaging
may dry up too much and cause jamming.
! If media has been removed from its wrapper, place it in its original
packaging and store in a cool, dark place on a level surface.
! Avoid moisture, excess humidity, direct sunlight, excess heat (above
95° F/35° C), and dust
! Avoid leaning against other objects or placed in an upright position
Before using stored media, do a trial printing and check print quality.