NEC LT180 - Manual (Page 34)

E-27
CO NT RO L
S-V IDE O I N
R Cb /Pb Y
L/m ono
LAMP
STATUS
POWER
AUTO
ADJ.
ON/STAND BY
SELECT SOURCE
MENU
UP
KEYSTONE PAGE
OFF
POWER
ON
PIC-MUTE
DOWN
Remote control Cabinet controls
POWER
STATUS
LAMP
POWER POWER
STATUS
LAMP
STATUS
LAMP
Power On Fan running Standby
Steady green light Blinking orange
light
Steady orange
light
NOTE: To avoid premature lamp failure, wait at least 5 minutes before turning on or off the projector.
3. PROJECTING AN IMAGE (BASIC OPERATION)
Second, press the ENTER button or press the ON/STAND BY or the POWER OFF button again.
The POWER indicator will glow orange. After the projector turns off, the cooling fans keep operating for 60
seconds (Cooling-off time).
Immediately after turning on the projector and displaying an image, you cannot turn off the projector for 60
seconds.
Third, turn off the Main Power switch. The POWER indicator will go out.
CAUTION
Do not unplug the power cable from the wall outlet or do not turn off the main power under any one of the
following circumstances. Doing so can cause damage to the projector:
• While the projector is turned on.
• While the cooling fans are running. (The cooling fans continue to work for 60 seconds after the projec-
tor is turned off).
Turning off the Projector
To turn off the projector:
First, press the ON/STAND BY button on the projector cabinet or the POWER OFF button on the remote control.
The “Power Off / Are you sure?” message will appear.