N-Tron 9000 Series - Manual (Page 106)

5/17/2007 page 106 of 138
NOTES A port can be a member to several VLANs, but can only have one PVID
Set Backpressure
Command Name port set backpressure
Description Enables or disables backpressure on a given port. This is normally used on
10Base setups and is a controlled by the hardware.
Syntax port set backpressure <port-no><enable | disable>
Parameters port-no
port number (1 ~ 24)
enable | disable
Backpressure enable or disable
Examples N-TRON/Admin#[1]> port set backpressure 6 enable
NOTES Check whether port-no is in the valid range. (1 ~ 24)
Set Intruderstate
Command Name port set intruderstate
Description Enables or Disables the intruder log.
Syntax port set intruderstate <enable | disable>
Parameters enable | disable
Enable or disable the intruder log
Examples N-TRON/Admin#[1]> port set intruderstate enable
NOTES This must be enabled for the intruder log to log anything.
Set Priority Level
Command Name port set prioritylevel
Description Sets the priority level of a given port.
Syntax port set prioritylevel <port-no><level>
Parameters port-no
port number (1 ~ 26)
level
priority level (0 ~ 7)
Examples N-TRON/Admin#[1]> port set prioritylevel 6 7
NOTES Priority State should be enabled to use this feature.
Show Configuration
Command Name port show config
Description Displays basic configuration settings on given ports.
Syntax port show config <port-no | all>
Parameters port-no | all
port number (1 ~ 26), you may enter all to see all the ports at once.
Examples N-TRON/Admin#[1]> port show config all
NOTES Check whether port-no is in the valid range. (1 ~ 26)
Show Intruders
Command Name port show intruder
Description Displays a list of MAC addresses that were not allowed on the network.
Syntax port show intruder
Parameters None
Examples N-TRON/Admin#[1]> port show intruder
NOTES Intruder log must be enabled before this will log anything.
Show Link Utilization
Command Name port show linkutilization
Description Shows the utilization statistics for all the ports including %bandwidth, %in,
%out, RX bytes, and TX bytes for each port.
Syntax port show linkutilization
Parameters None
Examples N-TRON/Admin#[1]> port show linkutilization
NOTES %Bandwidth is the %in or %out value that is higher, not the average value.