NEC R 37 Xtra - Manual (Page 10)

10
9
10
Terminal Board
VIDEO 1 VIDEO 2 RGB AUDIO RGB 1
REMOTE PC/EXT CTL
DIP SW
AC IN
SPEAKER SELECT
EXT SPEAKER
RGB 2
AUDIO AUDIO
HIGH 75 Ω
R MONO
IN
THROUGH
OUT
IN
THROUGH
OUT
THROUGH
OUT
IN
BNC S
HIGH 75 Ω
THROUGH
OUT
IN
R
THROUGH
OUT
IN
R
THROUGH
OUT
IN
BNC S
HIGH 75 Ω
IN
THROUGH
OUT
R/C R /P R G/Y/Y B/C B /P B H/CS V
HIGH 75 Ω HIGH 75 Ω
SPEAKRES MUST
HAVE MORE THAN
5WATT RATING
INPEDANCE 8 OHM
RIGHT LEFT
INT EXT IN
OUT
1 2 3 4 5 6 7 8
ON
( ) L
MONO ( ) L MONO ( ) L
J
I VIDEO 1
VIDEO 1 IN (BNC type)..... Connect a VCR or laser disk player here
to display the video.
S-VIDEO 1 IN..... Here is where you connect S-Video input from an
external source like a VCR.
THROUGH OUT (BNC type)..... Connect to a second monitor’ s video
input to relay the video signal input at VIDEO 1 IN.
THROUGH OUT (S-VIDEO)..... Connect to a second monitor’ s S-
connector input to relay the video signal input at S-VIDEO 1 IN.
75 Ω /HIGH Impedance Select Switch for BNC type..... Set to “75 Ω ”
during normal operation. In multiple connections using VIDEO 1
IN and THROUGH OUT (BNC type) terminals, set to “HIGH” on
all but the last monitor. Set to “75
Ω
” on the last monitor only.
AUDIO R IN..... This is your right channel audio input for stereo
sound.
AUDIO L IN (MONO)..... This is your left channel audio input for
stereo sound coming from video equipment or audio system. It
also serves as the mono audio input.
AUDIO R THROUGH OUT..... Connect to a second monitor’ s right
channel audio input.
AUDIO L THROUGH OUT..... Connect to a second monitor’ s left
channel audio input.
I
J RGB 2
R/C R /P R ,G/Y/Y,B/C B /P B , H/CS and V IN (BNC)..... These are analog
RGB input terminals.
Connect external components with R, G, B, H/CS, and V output
terminals to these analog RGB input terminals. Be sure that the
RGB connection cable is correctly attached to the corresponding
terminals.
R/C R /P R ,G/Y/Y,B/C B /P B , H/CS and V THROUGH OUT (BNC)..... Connect
to a second monitor’s RGB inputs to relay the RGB signal inputs at
R, G, B, H/CS, and V IN.
75 Ω /HIGH Impedance Select Switches for RGB and H/CS&V..... Set to
“75
Ω
” during normal operation. In multiple connections using R,
G, B, H/CS and V IN and OUT terminals, set to “HIGH” on all but
the last monitor. Set to “75
Ω
” on the last monitor only.