NEC R 37 Xtra - Manual (Page 9)

9
7
8
Terminal Board
F G
VIDEO 1 VIDEO 2 RGB AUDIO RGB 1
REMOTE PC/EXT CTL
DIP SW
AC IN
SPEAKER SELECT
EXT SPEAKER
RGB 2
AUDIO AUDIO
HIGH 75 Ω
R MONO
IN
THROUGH
OUT
IN
THROUGH
OUT
THROUGH
OUT
IN
BNC S
HIGH 75 Ω
THROUGH
OUT
IN
R
THROUGH
OUT
IN
R
THROUGH
OUT
IN
BNC S
HIGH 75 Ω
IN
THROUGH
OUT
R/C R /P R G/Y/Y B/C B /P B H/CS V
HIGH 75 Ω HIGH 75 Ω
SPEAKRES MUST
HAVE MORE THAN
5WATT RATING
INPEDANCE 8 OHM
RIGHT LEFT
INT EXT IN
OUT
1 2 3 4 5 6 7 8
ON
( ) L
MONO ( ) L MONO ( ) L
H
F RGB 1 (Mini D-SUB 15 pin)
RGB Input/Throughout..... Attach either end of the RGB Cable to a
computer, and then attach the other end to Input terminal. You can
then use Throught out terminal, if you wish, to output the computer
signal to a monitor. (If you do use a second monitor, turn the
monitor switch to “on.”)
75 Ω /HIGH Impedance Select Switch..... This switch should be “75
Ω
”
for normal use without external termination or when your RGB
signal should be terminated with 75
Ω . Switch to the “HIGH”
position when you have another monitor attached to your RGB
through-put connector.
G RGB AUDIO
AUDIO R IN..... This is where you connect RGB right audio output
from a computer or another RGB source.
AUDIO L(MONO)IN..... This is where you connect RGB left audio
output from a computer or another RGB source.
AUDIO R THROUGH OUT.....Connect to a second monitor’ s
RGB right audio input.
AUDIO L THROUGH OUT.....Connect to a second monitor’s
RGB left audio input.
H VIDEO 2
VIDEO 2 IN (BNC type)..... Connect another VCR or laser disk player
here to display the video.
S-VIDEO 2 IN..... Connect S-Video input from another external
source like a VCR.
THROUGH OUT (BNC type)..... Connect to a second monitor’ s video
input to relay the video signal input at VIDEO 2 IN.
THROUGH OUT (S-VIDEO)..... Connect to a second monitor’ s S-
connector input to relay the video signal input at S-VIDEO 2 IN.
75 Ω /HIGH Impedance Select Switch for BNC type..... Set to “75 Ω ”
during normal operation. In multiple connections using VIDEO 2
IN and THROUGH OUT (BNC type) terminals, set to “HIGH” on all
but the last monitor. Set to “75
Ω
” on the last monitor only.
AUDIO R IN..... This is your right channel audio input for stereo
sound.
AUDIO L IN (MONO)..... This is your left channel audio input for
stereo sound coming from video equipment or audio system. It
also serves as the mono audio input.
AUDIO R THROUGH OUT..... Connect to a second monitor’ s right
channel audio input.
AUDIO L THROUGH OUT..... Connect to a second monitor’ s left
channel audio input.