Nokia 150T - Manual (Page 24)

GB 24
NAVI BARS
Settings folder ☛ TV
To open this menu, you will be asked to enter your access code.
The access code is set to 1234 at the factory.
From this menu, you can adjust the audio/video settings for your Mediamaster.
TV screen format
Select your TV screen format.
The 4:3 format is the standard format for most TV screens.
Select 16:9 for a widescreen TV.
Position of the RGB output
Adjust the horizontal position of the TV picture with cursor left/right .
Set transparency level
Adjust the transparency level of the graphics in the menus by using
cursor left/
right .
Select digital audio format
Select audio format for the digital output . (The upper audio output on the rear of
the Mediamaster). AC-3 when the sound is transmitted in Dolby™ Digital format;
PCM for ordinary digital sound. NOTE: When you select AC-3, there will be no sound
output from the analogue audio connections.
Picture format
If you have a TV set with a 4:3 picture format and the transmission is in 16:9, you
can select “Fullscreen” or “Letterbox”.
Fullscreen will fill up the screen but cut off some information on the lefthand and
righthand sides.
Letterbox will give a complete picture, but leave black areas at the top and bottom.
TV standard
When the Mediamaster is connected to the TV by an RF cable, you may need to
select the correct TV standard system.
Select
PAL G when the box is used outside the UK and France.
Select PAL I when the box is used in the UK.
Select SECAM when the box is used in France.
letterbox fullscreen
RF modulator output channel
Select this alternative if you have to change the RF channel. (Channel 43 is preset
in the factory.)
Select a new RF output channel number. Channels found during the first time in-
stallation will not be selectable.
When you change the RF channel number, you must also change the TV to the same
value. If you do not, there will be no picture and sound.