NEC LT150 - Manual (Page 24)

E–24
AC IN
PC CARD USB
VIDEO
S-VIDEO
RGB
AUDIO
PC CONTROL
MEN U
EN T ER
CANCEL
SEL EC T
AUTO ADJU ST
PC CAR D ACCESS
STATUS POWER
ON / STAND BY
SOURCE
VIDEO
S-VIDEO
RGB
AUDIO
PC CONTROL
RGB INPUT
Y Cb Cr
R L
R L
You can connect your projector to a DVD player with component outputs or Video output. To do so, simply:
1. Turn off the power to your projector and DVD player.
2. If your DVD player has the component video (Y,Cb,Cr) output, use the optional 15-pin-to-RCA
ן3 cable to connect your DVD player to the
RGB INPUT connector on the projector.
For a DVD player without component video (Y,Cb,Cr) outputs, use common RCA cables (not provided) to connect a composite VIDEO
output of the DVD player to the Video Input of the projector.
3. Turn on the projector and DVD player.
NOTE: Refer to your DVD player’s owner’s manual for more information about your DVD player’s video output requirements,
Connecting Your DVD Player
Optional 15-pin-to-RCA ן 3 cable (optional)
(Component V )
Audio cable
(not supplied)
DVD player
White
Red
Y
Cb
Cr
White
Red
Audio Equipment