Renesas Emulation Pod M306V2T-RPD-E - Manual (Page 35)

( 33 / 72 )
3.4 Circuits of Data Slicer I/O Signal and OSD Clock I/O Signal
With this product, the parts used for the data slicer and OSD clock circuit are attached by sockets for
replacement. Figure 3.8 shows the position of each part used for the data slicer and OSD clock
circuits, and Figures 3.9 to 3.12 show the circuit diagram and the constants of board-mounted parts.
Figure 3.8 Position of each part
(1) Figure 3.9 shows the numbers of parts which are connected to the CVIN pin, the constants of parts
and the connection circuits.
Figure 3.9 Signal circuits of CVIN pin