Radio Shack CT-503 - Manual (Page 17)

17
3. Press to call the phone number. IU (in use) flashes
and diALing then the number called appear briefly,
then on reappears.
4. To end the call, press .
Note: Closing the cover does not end or disconnect the call.
System Busy Message
In addition to the normal busy signal you hear when a num-
ber you call is busy, your phone sounds tones and displays
these messages to indicate that it cannot complete a call.
When either of these conditions occur, you can press
again to redial the number immediately (see “Using Automat-
ic Redial” on Page 22), or press
then dial the number
again.
Tone You See Description
Fast Busy Snd to
rEdiAL
The cellular system is
busy.
High/low Snd to
rEdiAL
The cellular system
could not complete the
call.
SND
END
SND
END
17-1112.fm Page 17 Wednesday, July 21, 1999 2:34 PM