Establishing communication – RocketFish ROCKETBOOST RF-RBWHP01 User Manual

Page 18

Advertising
background image

18

Note: It can take about eight to nine hours to charge the batteries. The batteries will
last up to ten hours with continuous use (depending on the headphone volume level
and distance from the docking station or other Rocketboost sender).
Note: The headphones can be charged even if the docking station or headphones
are turned off.

Establishing communication

Rocketboost products form an audio network and each Rocketboost
receiver can select the audio from any Rocketboost sender in the
network.
Every Rocketboost network must contain one hub device, which
helps devices join the network. The network can have only one hub,
which you can enable using the hub switch on the back of all
Rocketboost senders and sender/receivers. If this is your first
Rocketboost product, you should make the docking station sender
device the hub, if you already have Rocketboost products, you should
disable hub mode on this device.

Important

: Hub devices must always have power for your network to operate. The hub

device can be in standby (power saving) mode, but must stay plugged in.

Turning on the system

To turn on the system:

Note

: The headphones and docking station were previously paired at the factory.

When an active link is established between them, the power indicators on the
headphones and docking station all light steadily.

1

Set the POWER switch on the left earpiece of headphones to ON. The

power indicator:

• Lights steadily Blue if the headphones and docking station are

paired.

• Blinks slowly if the headphones and docking station are not paired.

2

Press the POWER button on the docking station. The Standby indicator

turns off and the power indicator turns:

• Green when the HUB switch on the docking station is set to ENABLE.

RF-RBWHP01_11-0883_MAN_V2.fm Page 18 Tuesday, October 18, 2011 11:04 AM

Advertising