Runco DTV-992 User Manual

Page 40

Advertising

Change password

This item is password protected.
Highlight ‘Change Password’ with the control disc and press
ENTER.

The current password is displayed. The new password must consist
of 4 digits between 0 and 9. Push the control disc to the left or to the
right to select the digits to be changed. Use the numeric keys to
enter the new digits.
Press ENTER to save the new password. Before saving the new
password, a confirmation screen will be displayed.
Press EXIT to return to the Projector Set-up menu without saving the
new password.
When the displayed password is correct, press ENTER to save.
If not correct, press EXIT to cancel the saving.

Change Language

The ‘Change Language’ function offers the possibility to change the
language of the screen menus to :

- English
- Spanish
- French
- German

Highlight ‘Change Language’ with the control disc and press

ENTER.

Push the control disc up or down to select the desired language and
press ENTER to change the language.

Total Run Time

Highlight ‘Total Run Time’ with the control disc and press ENTER to
display the amount of time the projector has played since its first
start up at the factory.

Note : all projectors leave the factory after a burn-in period of
approximately 100 hours.

ENTER gives a confirmation message before deleting.
EXIT returns to the Path Selection main menu.

7-4

Service Mode

ENTER saves the entered password.
EXIT returns without saving.

ENTER gives the selected item.
EXIT returns to Service mode menu.
ADJUST returns to the Operational mode.

PROJECTOR SET-UP

IDENTIFICATION
TOTAL RUN TIME

CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE: operating