2location and function of controls, Rear panel terminology, Front panel terminology – Runco DTV-992 User Manual
Page 9
IR Sensor
receiver for control signals transmitted from the
RCU.
IR Remote
Connector for remote input for hard wired remote
Control.
EYE-Q Camera
RS 232 Input Port
Connection between the DTV-992 / 992 ULTRA and an IBM
PC (or compatible) Or MAC (RS422) for remote computer
control and data communication.
RS 232 Output Port
RS232 Input Port allows a communication link for PC 0r
MAC to the next projector in a series of projector.
2-1
2
LOCATION AND FUNCTION OF CONTROLS
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation.
Off On
Power/Mains
Comm Port
Port 3
B
G
R
Comp/
HSYNC
VSYNC
Green=Oper.
Red=Stby
VIDEO
1
2
3
4
5
6
7
8
9 10
REAR PANEL TERMINOLOGY
Power Switch: press the switch to turn the projector ON.
Depending on the hardware set-up of the projector during
installation, the projector switches to ‘Standby’ or to ‘Opera-
tional’ mode. If in standby, the standby LED lights up.
AC Power Input
Communication Port
•
allows connection of a remote IR receiver unit to the
projector.
Port 3
RGB Analog Input (9 pin female sub D connector). Allows a
character generator, microcomputer, etc. having analog
RGB outputs to be connected to the projector.
Port 4/5: RGB-S Input (5x BNC connector):
RGB-S input: allows a character generator, microcomputer,
video camera, etc. having analog RGB Output to be con-
nected to the projector.
Line inputs
–
signals RED-GREEN-BLUE
–
COMPOSITE sync. signal
–
Tri level sync. signal (option>)
2
3
4
S-VIDEO Input: (Not Active)
75 ohm Termination Switch for S-Video signals
VIDEO Input: (Not Active)
75 ohm Termination Switch for Video signals:
(Not Active)
Projector Pilot Lamp: indicates the Status of the
projector.
–
unlit: mains (power) switch is not pressed.
–
lit: mains (power) switch is pressed and the
indicated color shows the projector mode:
Green color : operational mode of the projector.
Red color: standby mode of the projector.
7
8
1
6
5
9
10
11
12
13
14
FRONT PANEL TERMINOLOGY
RS232 OUT
RS232 OUT
IR
IR
REMOTE
REMOTE
RS232 IN
RS232 IN
11
12
13 14
T
V
LE
NS
8mm
T
V
LENS
8m
m
15
15