RCA Fibre Channel Switch - Manual (Page 27)

Maintenance procedures
16 April, 2003 Fibre Channel Switch 27
Maintenance procedures
You may wish to use the following procedures to recover from faulty configurations
or other problems. Since these procedures stop all traffic on all Fibre Channel ports,
be sure to take the switch out of service before performing any of these tasks.
Resetting the switch to factory defaults
Resetting factory defaults returns your QLogic SANbox2 Switch to its original
configuration, although it does not reset the password. After resetting factory defaults,
you must restore all the Grass Valley settings and site-specific network settings
described earlier in this manual.
To reset the QLogic SANbox2 Switch to factory defaults:
1. Use Telnet over the Ethernet LAN or a serial communication application such as
Hyperterminal through an RS-232 connection to enter access the Command Line
Interface.
2. Log in to the switch with username admin and password password, all in lowercase
characters.
3. Type the following command to enter the administrator mode, which allows you
modify settings.
sb5_8port #> admin start
4. Type the following command to restore the factory defaults:
sb5_8port #> reset factory
5. Reconfigure the switch for your environment by following all the procedures
described in “Configuring your Fibre Channel switch” on page 14.
Resetting the switch manually
In some situations, you may be unable to use the reset factory command to restore
factory defaults. For example, if you don’t remember the admin password, you cannot
enter administrator mode to use the reset factory command.
The Reset/Force PROM button on the front panel allows you to bypass the normal
switch control interfaces in unusual situations.
To enter the Force PROM mode do the following:
1. Connect a workstation to the switch through the Ethernet, or Serial port.
2. Power down the switch.
3. The Reset/Force PROM button is located through a hole just above the Heartbeat
LED on the front panel. Use a small pointed instrument such as a straightened
paper clip to press and hold this button while turning on the power on the switch.
4. Wait at least one minute until the Heartbeat LED light remains constant (without
blinking).
5. Establish communications with the switch using the command line interface. You
may find it easier to use the serial interface for this operation.
6. Log in to the switch as user prom, with password prom.