Regency I31-NG3 - Manual (Page 9)

9 Regency I31-3 Gas Fireplace Inbuilt
Logs D)02-46 and E)02-47 in position.
6) Place the Left Top Log D)02-46 on the pin
on Log C)02-56 and on top of the cutout
on Log A)02-43.
7) Place the notch in Center Log E)02-47 over
Log B)02-45 and across the cutout on Log
A)02-43.
Cutout
Pin
Cutout
Notch
8) Position notch in Front Right Log F)02-48 on
Log E)02-47 and push the bottom right edge
against the bracket on the burner tray and
the front edge of the rear burner.
Notch Bracket
10) Place the embers and Rockwool on the
exposed front burner tray.
11) Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other. If there is any flame
hesitation, check that area for any blockage
of the burner port.
12) Install flush glass and optional bay glass as
per instructions in this manual.
D)02-46
E)02-47
F)02-48
9) Place Front Left Log G)02-44 onto the 2
front pins as shown.
G)02-44
C)02-56
A)02-43
B)02-45
A)02-43
B)02-45
E)02-47
C)02-56
A)02-43
B)02-45
F)02-48
D)02-46
G)02-44
E)02-47
F)02-48
B)02-45
Bracket
A)02-43
Front edge of
rear burner
The bottom right edge of Log F)02-48 must
sit snugly against the bracket and the front
edge of the rear burner.
Side View
Pins on Rear Log Support
Logs A)02-43, C)02-56, and
B)02-45 in position
A)02-43
B)02-45
C)02-56
INSTALLATION
4) Place Front Right Log B)02-45 on the two
pins as shown.
5) Place the Middle Left Log C)02-56 on the
two pins as shown.