Radio Shack 43-5560 - Manual (Page 41)

Caller ID
41
2. Press TALK/FLASH or SPEAKER . The
displayed phone number dials
automatically.
From Talk mode
1. Press TALK/FLASH or SPEAKER .
2. View the Caller ID message you want
to dial (see “Viewing the Caller ID List”
on page 39).
3. Press the DIAL soft key. The displayed
phone number will be dialed.
Long Distance calls and Area Code
Setting/Cancellation
While the present Caller ID information is
displayed, pressing /tone/< will place or
remove the prefix “1” in the display to set the
call for a long distance call, or pressing #/> will
set or cancel an area code (see “Setting the
Area Code” on page 23). Ô
Storing Caller ID messages in the
Phonebook
Messages shown in the Caller ID list can be
stored in the phonebook. The phone
number and name of the party on the Caller
ID list can be stored in memory. Ô
1. When the phone is in standby mode,
view the Caller ID message to be stored.
Then press the
STORE soft key. Store/
Edit Name appears.
2. To complete the setting, follow the
steps 3-8 in “Storing Phone Numbers,
Names, Distinctive Rings, and Speed
Dial” on page 31-32.
Ô
NOTES
Ô
• When a long distance
call has been set,
1
appears in the display.
• If a call comes in via a
telephone system that
does not offer Caller ID
service, no information is
stored.
• If the Caller ID message
was received as a
private/unknown
number, or the message
does not have the
number, you cannot
store the message in the
Phonebook. If it was
received as private/
unknown name, the
message will be stored
as <No Name>.
• Even if the 100 memory
locations are full, the
message will be stored
in the Phonebook.
However, the message
will be erased from the
Caller ID list.
43-3580.book 41 ページ ２００４年１月２６日 月曜日 午前１０時１９分