RocketFish RF-RBUSB - Manual (Page 22)

22
6 Press and hold the on the Rocketboost hub device for more
than three seconds to put it into joining mode. The power indicator
starts blinking rapidly and the unit will stay in joining mode for 30
seconds. The diagram (below) shows an example of this. In this
example, the wireless sender/receiver is the hub device.
7 Press and hold the on your other Rocketboost device for more
than three seconds to put it into joining mode.
• When successfully joined, the power indicator LEDs on both
products will stop blinking and stay on.
• If joining fails after 30 seconds, the power indicator LEDs will
begin flashing at a slower rate. If this occurs, repeat the above
steps.
• Repeat steps 2-7 for each additional Rocketboost device you
are adding to your network.
Using your wireless sender/receiver as a sender
Note : When using the wireless sender/receiver as a sender, the Sender
mode indicator LED will light when you are correctly connected to an
audio source.
To use your wireless sender/receiver as a sender:
1 Turn on the audio source connected to the wireless
sender/receiver. Make sure the volume of the audio source is
turned up and not muted, otherwise no audio will be sent over the
Rocketboost network.
2 Select either USB-In or LINE-In using the remote control, depending
on which audio input you are using.
Power on
indicator
RF-RBUSB_11-0204_MAN_V1.fm Page 22 Monday, May 2, 2011 8:04 AM