RocketFish RF-RBUSB - Manual (Page 28)

28
• Each network must contain both a wireless sender device and a
wireless receiver device. Do you have both a wireless sender and a
wireless receiver device?
Problem Solution
No communication
between the
Rocketboost sender and
receiver devices. • Make sure that the power indicators of the Rocketboost wireless sender and
wireless receiver devices are lit solidly. If the indicators are blinking, see
“Establishing communication” on page 21.
• If the joining process is failing, make sure that only one of your Rocketboost
wireless devices has the Hub switch enabled. Note that the hub device will
be the only device with the green power indicator. Non-hub devices have a
blue power indicator.
No sound • Check the volume level of the audio sources connected to the wireless
sender.
• Make sure that all of the audio cables are connected correctly.
• Make sure that the power indicators of the Rocketboost wireless sender and
wireless receiver devices are lit solidly. If the indicators are blinking, see
“Establishing communication” on page 21.
• Make sure the audio source connected to your wireless sender is On.
• Make sure the wireless sender or wireless receiver devices are not Muted.
The Receive mode indicator light blinks when the device is muted.
• When using computer USB audio, make sure your computer audio volume is
turned up and not muted. Depending on your computer and operating
system you may have to adjust this in the operating system volume settings
or in the application you are using (for example, Windows Media Player).
My Rocketboost remote
will not control the
volume. I can’t turn the
volume up or down. • Make sure you have removed the insulation sheet in the battery tray of the
Rocketboost remote.
• To maximize your volume level through the system, make sure your source
devices (i.e., A/V receiver, MP3 player, etc.) have their volume turned up to at
least 50% of their volume level.
• The battery in your remote may be dead. Try replacing it with a new battery.
• Rocketboost remote volume controls are not supported by the RF-RBUSB
wireless sender/receiver, since it uses a line-level output. The volume can be
controlled at the amplifier or powered speaker connected to the wireless
sender/receiver.
RF-RBUSB_11-0204_MAN_V1.fm Page 28 Monday, May 2, 2011 8:04 AM