Raymarine Wind & Close Hauled Wind Instrument ST60 - Manual (Page 11)

Preface ix
Mounting options
If you do not want to surface mount your ST60 instrument, options are available
for:
• Flush mounting. If you have ordered the flush mounting option a low-profile
bezel and four fixing screws are also provided.
• Bracket mounting.
Parts supplied
Unpack your ST60 instrument and check that the following items are present:
Either
• Item 1a, ST60 Wind instrument, fitted with standard bezel for surface mount-
ing
• or
• Item 1b, ST60 Close Hauled Wind instrument, fitted with standard bezel for
surface mounting.
• Item 2, Fixing studs (2).
• Item 3, Thumb nuts (2).
• Item 4, Gasket.
• Either
• Item 5a, Wind Vane (not with ST60 Close Hauled Wind)
• or
• Item 5b, Rotavecta (not with ST60 Close Hauled Wind).
• Item 6, SeaTalk interconnection cable.
• Item 7, Power cable (not with ST60 Close Hauled Wind).
• Item 8, Instrument Cover.
• Item 9, Junction Box (not with ST60 Close Hauled Wind).
• Item 10, Owner’s Handbook. A Warranty document and fitting templates are
included in this Handbook.
• Item 11, Cue Card.
• Spare spade terminals are also provided, to re-terminate transducer cables if
they have to be cut to facilitate installation.
Note: The above packing list is for an ST60 Wind system. Where an instrument is pur-
chased separately, a transducer and junction box are not included.