Raymarine Wind & Close Hauled Wind Instrument ST60 - Manual (Page 26)

14 ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook
age the equipment, but may cause the loss of some information and may
change the operating mode.
• Raymarine specified cables are used. Cutting and rejoining these cables can
compromise EMC performance and must be avoided unless doing so is
detailed in the installation manual.
• If a suppression ferrite is attached to a cable, this ferrite should not be
removed. If the ferrite needs to be removed during installation it must be reas-
sembled in the same position.
Suppression Ferrites
The following illustration shows typical cable suppression ferrites used with
Raymarine equipment. Always use the ferrites supplied by Raymarine.
Connections to Other Equipment
If your Raymarine equipment is to be connected to other equipment using a cable
not supplied by Raymarine, a suppression ferrite MUST always be attached to the
cable near the Raymarine unit.
3.2 Procedure
As it is not possible to describe procedures for all possible installation scenarios,
the procedures given here describe the broad requirements for installing wind
transducers and ST60 Wind instruments. Adapt these procedures as appropriate,
to suit your individual requirement.
CAUTION:
Where it is necessary to cut holes (e.g. for cable routing and
instrument mounting), ensure that these will not cause a hazard
by weakening critical parts of the vessel’s structure.
Unpacking
Unpack your ST60 instrument and check that the items described in the Preface
are present:
D3548-6