Radio Shack 4-in-One Smart Light-Up Remote Control - Manual (Page 15)

15
If necessary, repeat these steps for each de-
vice.
Note: Some VCRs and CD players do not have
a POWER key on the original remote. If so,
manually turn on the VCR, insert a tape or CD,
and repeat the manual code search using
PLAY
instead of POWER . When the device responds,
press P . The red light blinks twice.
Determining the 4-Digit Code
After you set up your remote control using the
manual code search, you can find which 4-digit
code the remote control is set to by following
these steps.
1. Press the device key you want to get the
manufacturer's code from, then hold down
P until the red light blinks twice.
2. Press 9 9 0 . The red light blinks twice
again.
3. Press 1 , then count the number of times
the red light blinks. This is the first digit of
the 4-digit code.
Note: If the red light does not blink, the
digit is a
0 .
4. Repeat Step 3 three times to find the sec-
ond, third, and fourth numbers of the 4-
digit manufacturer's code, pressing
2 , 3 ,
and 4 respectively for each additional digit.
15-1993.fm Page 15 Wednesday, October 20, 1999 12:03 PM