Radio Shack 4-in-One Smart Light-Up Remote Control - Manual (Page 5)

5
PREPARATION
INSTALLING BATTERIES
Your remote control requires four AAA batter-
ies (not supplied) for power. For the best per-
formance and longest life, we recommend
RadioShack alkaline batteries.
Cautions:
• Use only fresh batteries of the required
size and recommended type.
• Do not mix old and new batteries or differ-
ent types of batteries.
• Do not press any of the remote control's
keys while installing batteries.
Note: You do not need to reprogram your re-
mote control after removing the batteries, be-
cause no stored information is lost during
battery replacement.
1. Press the battery compartment cover's tab
and lift off the cover.
2. Place the batteries in the compartment as
indicated by the polarity symbols (+ and –)
marked inside.
3. Replace the cover.
When the remote control's range decreases or
it stops operating properly, replace the batter-
ies.
Caution: Always remove old or weak batteries.
Batteries can leak chemicals that can destroy
electronic parts.
Warning: Dispose of old batteries promptly
and properly. Do not burn or bury them.
Note: Do not place objects on top of the re-
mote control after you have installed the batter-
15-1993.fm Page 5 Wednesday, October 20, 1999 12:03 PM