Radio Shack 43-329 - Manual (Page 8)


Te
le
ph
on
e
Se
tu
p
Wall Mount Installation
Position the telephone base as shown below. Insert the extended
tabs (marked B) of the wall bracket into the slots on the back of the
telephone base (marked B). Push the telephone base down until it is
securely in place.
If you are using a DSL filter, plug the line cord into the filter now. Route
the telephone line cord (or DSL filter) through the wall bracket hole.
Route the power cord out of the bottom of the telephone.
Plug the telephone line cord (or DSL filter) into the wall jack. Plug the
power adapter into a power outlet not controlled by a wall switch.
Align the holes on the bracket with the standard wall plate and slide the
bracket down until it locks securely. Bundle the telephone line cord and
power adapter cord neatly with a twist tie.
1.
2.
3.
4.
1 2
3
DSL filter
(optional, not
included)