Raritan Engineering Command Center CC-SG - Manual (Page 197)

C HAPTER 12: ADVANCED ADMINISTRATION 181
2. Click Add to add a new firmware file. A search window appears.
Figure 222 Search Window
3. Click on the Look In drop-down arrow and navigate to locate the firmware file in your
system. When you find the firmware, select it, and click Open. The firmware name will
appear in the Firmware Name field.
4. Click Close to close the Firmware Manager screen.
Delete Firmware
1. On the Setup menu, click Firmware Manager. The Firmware Manager screen appears.
2. Click on the Firmware Name drop-down arrow and select the firmware to be deleted.
3. Click Delete. The Delete Firmware window appears.
Figure 223 Delete Firmware Window
4. Click Yes to delete the firmware or No to close the window.
5. Click Close to close the Firmware Manager screen.
CommandCenter NOC
Adding a CommandCenter NOC (CC-NOC) to your setup will expand your target management
capabilities by providing monitoring, reporting, and alert services for your serial and KVM target
systems. Please see Raritan’s CommandCenter NOC documentation for detailed instructions on
installing and operating your CC-NOC appliance.
Important: In the following procedure, passcodes are generated. You need to
provide these passcodes to the CC-NOC administrator who needs to configure
them in CC-NOC within five minutes. Avoid transmitting the passcodes over
email or other electronic means to avoid a possible interception by automated
systems. A phone call or exchange of written codes between trusted parties is
better protection against automated interception.