Rear panel – Roland UA-25 EX User Manual

Page 13

Advertising
background image

13

Panel Descriptions

fig.rear.eps

14. Master output jacks (TRS balanced type, RCA phono type)

These are output jacks for analog audio signals. The phone jacks and RCA phono jacks output the
same signal. You may use whichever type of jack is appropriate for the connected device or the
type of cable.

* The TRS balanced master output jacks are wired as

shown on the right. Before you make connections, check
the wiring of the equipment you’re connecting.

15. Ground lift switch

Normally, you can leave this in the NORMAL (NOR) position. If you
experience noise due to a ground loop, you may be able to
eliminate the noise by setting this to the LIFT position, so that the
sleeve (SLEEVE) pin of the master output TRS balanced jacks is
disconnected from ground.

16. Digital output connector (optical)

This is an output connector for digital audio signals. Use this to digitally output audio signals to a
digital audio device such as an MD or DAT. Use an optical cable to make connections.

17. Digital input connector (optical)

This is a input connector for digital audio signals. Use this to digitally input audio signals from a
digital audio device such as a CD, MD, or DAT. Use an optical cable to make connections.

18. MIDI IN/OUT connectors

These are MIDI connectors which transmit and receive MIDI messages between computer.

* The MIDI IN/OUT connectors are not available, if you’re using the UA-25EX in Standard driver

mode (p. 45).

19. Sample rate select switch

This specifies the sample rate at which audio is recorded or played back. If you change the setting
of the sample rate select switch, you must close all software, disconnect the USB cable that
connects the UA-25EX to your computer, and then reconnect the USB cable.

* If you are using Standard driver mode (the Advanced Driver switch turned off), the sample rate

is fixed at 44.1 kHz regardless of the sample rate select switch setting.

* If you want to use 96 kHz, set the switch to “96R” while recording and to “96P” while playing

back.

Rear panel

21

23

16

14

17

18

19

15

22

20

GND (SLEEVE)

HOT (TIP)

COLD (RING)

Mater output jack
(TRS balanced type)

NOR

LIFT

UA-25EXCW_e.book 13 ページ 2009年4月13日 月曜日 午後12時33分

Advertising