Roland UA-25 EX - Manual (Page 37)

37
Basic Connections and Settings
fig.digital2.eps
Connections
Connect your digital device to the digital output connector.
Sample rate select switch
Set this to match the sample rate of your digital recording device and the sample rate of your
software or the audio data you are playing back.
If you change the UA-25EX’s sample rate, you must disconnect the USB cable that connects the
UA-25EX to your computer, and then reconnect the USB cable in order for the new setting to take
effect.
* If you recorded at 96 kHz, you must set this switch to “96P” (playback).
Other notes
The signals being input from the combo input jacks are not output directly from the digital output
connector.
Recording to an MD or other digital device
MD/DAT Recorder,
HDD Recorder, etc.
Specify the Sample Rate:
Select a sample rate that your recording
device is able to record. Choose the same
sample rate as your software or the audio
data you are playing back.
UA-25EXCW_e.book 37 ページ ２００９年４月１３日 月曜日 午後１２時３３分