Roland UA-25 EX - Manual (Page 33)

33
Basic Connections and Settings
Input sensitivity knob
Use the input sensitivity knob to adjust the input level. You can obtain the best recording quality
by turning the input sensitivity knobs as high as possible without causing the peak indicators to
light.
Sample rate select switch
Set this to the same sample rate as selected in your recording software.
If you change the UA-25EX’s sample rate, you must disconnect the USB cable that connects the
UA-25EX to your computer, and then reconnect the USB cable in order for the new setting to take
effect.
STEREO/MONO select switch (Direct Monitor section)
This selects whether the input signal is to be monitored in stereo or in monaural.
Direct Monitor switch
You can turn this on to monitor the input signal.
Turn this off if you want to pass the signal “through” within your software.
Direct Monitor volume knob
This adjusts the balance between the monitor volume knob and the volume of the audio being
played back from your computer.
Using the direct monitor volume knob to adjust the volume will not affect the recording level.
UA-25EXCW_e.book 33 ページ ２００９年４月１３日 月曜日 午後１２時３３分